PAPERduino’s design

This is a fully func­ti­o­nal ver­si­on of the Ardui­no. We eli­mi­na­ted the PCB and use paper and card­bo­ard as sup­port and the result is.. the PAPERduino 😀

This is the the first ver­si­on of the layout design, next we will try more designs, and other mate­ri­als. You just need to print the top and the bot­tom layouts, and glue them to any kind of sup­port you want. We hope that you start making your own boards. If you do, ple­a­se sha­re your pho­tos with us, we would love to see them 😉

The­re is no USB direct con­nec­ti­on, so to pro­gram the paper­dui­no you will need some kind of FTDI cable or adap­ter. One of this pro­ducts will be fine:
FTDI cable from Ada­fruit Industries
FTDI adap­ter from Sparkfun

Down­lo­ad PDF

Com­po­nents list:
1 x 7805 Vol­ta­ge regulator
2 x LEDs (dif­fe­rent colors)
2 x 560 Ohm resis­tors (betwe­en 220oHm and 1K)
1 x 10k Ohm resistor
2 x 100 uF capacitors
1x 16 MHz clock crystal
2 x 22 pF capacitors
1 x 0.01 uF capacitor
1 x button
1 x Atmel ATMega168
1 x soc­ket 28 pin
Fema­le and Male headers

Ins­truc­ti­ons:
Use a nee­dle to punc­tu­re the holes for your components.

Don’t rush, pla­ce one com­po­nent after another and do all the sol­der work carefully.

Fol­low the con­nec­ti­on lines.

And this should be the final look of your paper­dui­no connections.